Skip to Content

SNP Optimizer

Dear Expert,

I have this issue regarding SNP Optimizer ...

I have Demand from Distribution Center 2014

two Production location are available to produce 2013, 2015

Capacity not available for location 2013 , but still the (cost - Effective)

When i Run Optimizer the APO choose location 2013 even with none available capacity

Pleaase note that in optimizer profile i mark "Production Capacity " as constraint

How i can let the system choose the other location 2015 in this case ?

Thanks

Rami

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Nov 15, 2011 at 04:32 AM

    Hi,

    Increase the cost of delay so that the optimizer will choose the other location 2015.

    Regards,

    Manimaran M.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Rami AbdElFattah Mohamed

      Hi,

      Apart from the points mentioned earlier, pls check the following.

      1. Have you maintained extended capacity in resource master? Is the resource created as SNP Bucket resource? Pls check the resource master correctly

      2. When a planned order is created in this case, does it attach the correct PPM?

      3. In the transaction /sapapo/mvm, have you clicked the check box for 'No planned orders without source of supply' ?

      Regards

      Manotosh

  • avatar image
    Former Member
    Nov 15, 2011 at 02:46 PM

    hi,

    just checking,

    there are no procurement options on 2013 right?

    because it might be cost effective to procure from outside than to produce at 2015.

    Regards,

    Sandeep

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 15, 2011 at 05:25 PM

    hi,

    when u mentioned 'E' that itself says, it is inhouse produced.

    I was checking if the procurment type is 'X' and can be subcontracted.

    Regards,

    Sandeep

    Add comment
    10|10000 characters needed characters exceeded