cancel
Showing results for 
Search instead for 
Did you mean: 

Variant Config

Former Member
0 Kudos

Hi, Experts

We are sending the queries given below after collective discussion

1) Dependency can be assigned at Characteristic, Characteristic value, Configuration profile, BOM and Routing , How to understand that particular dependency is to be assigned at which level?

2) Dependency are four type, Precondition, Selection Condition, Procedure, Constraint? When these dependency types to be used?

3) Explain what the source codes are and which Syntax is used for each Dependency type?

What is the utility and in what cases should it be used.

4) Table is defined by using CU60? Why it is used and in which scenario it is used?

5) What are Dependency Net?

6) How many classes to be assigned to Configure Material Master, Should we prefer single Class with all the characteristicsu2019. If we need to assigned more than a class what is use ? How we have to decide multiple classes.

7) Configurable material without using material type KMAT , Is only tick for Configurable material in Basic data view to be enabled or is there any other field which needs to be populated.

8) In Sales view Item Category group options are 0002 and 0004 for Configurable material, Which scenario 0002 or 0004 is used.

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi,

The forum rule is: one question per thread. Please reorganize your question to few more threads to ask.

Thanks,

Gordon