Skip to Content
author's profile photo Sarathchandra Banda
0
Sarathchandra Banda

Doubt regarding Debug mode

Posted on Nov 09, 2011 at 11:21 AM 11 Views

Hi All,

I have a small doubt that, Is it possible to disable the debug mode at a certain point of perform statement??

Add a comment
10|10000 characters needed characters exceeded

Assigned Tags

Related questions

3 Answers

  • author's profile photo Former Member
    Former Member
    Posted on Nov 09, 2011 at 11:53 AM
    0

    Hi Sarath,

    Just select Debugger Menu - > Debugging OFF.

    Regards,

    Karthik D

    Add a comment
    10|10000 characters needed characters exceeded

  • author's profile photo Sandeep Kumar
    Sandeep Kumar
    Posted on Nov 09, 2011 at 05:52 PM
    0

    Hi Sarath,

    If you want to stop entire debugging and exit the application use EXIT DEBUGGER AND APPLICATION option from the debugger menu.

    If you want to exit debugger and see the output then just select EXIT DEBUGGER option from the debugger menu.

    If the control went inside perform statement i.e FORM & ENDFORM then press F7 to come back to your code next to perform statement.

    If you are on perform statement and doesn't want to go inside the perform statement but just want to execute the perform then press F6.

    Hope this helps you.

    << Moderator message - Point begging removed >>

    Regards,

    -Sandeep

    Edited by: Rob Burbank on Nov 9, 2011 1:27 PM

    Add a comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on Nov 09, 2011 at 06:21 PM
    0

    Hi,

    Below options are available:

    F5 (SINGLE STEP)

    -

    Single Step; means debug line by line

    F6 ( EXECUTE)

    -

    Execute the subroutine / Function Module without entering

    into the definition.

    F7 ( RETURN)

    -

    After entering into the subroutine/ Function module

    definition , To comeout from any point of definition.

    F8 ( CONTINUE)

    -

    Jumps to next break/watch point if available. otherwise it

    executes the whole program and comeout of it.

    Thank you!

    Reetesh

    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.