Skip to Content

Lot Rejection

Dear Gurus,

my client requirement if one sample is rejected from the lot whole lot will be rejected:

in QDP1 i have made sample scheme & attach it to sampling plan & this sampling plan is attached to Quality plan for

Result recording .

lot size:0 to 100 EA ,Sample size :5

what we have to define in C1& D1.

how can we check the result wheteer it is working fine o r not???

Siva

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Oct 29, 2011 at 02:01 PM

    C1= 0 & D1=1

    Create a manual lot in QA01 & then check in QA32 while doing Result recording.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member SIVA KUMAR

      Valuation of Inspection lot is different from the valuation of Inspection char during the result recording & both are different/Independent activities.

      What you can do "System should valuate the Inspection char as rejected even if one piece is fail."

      You have followed steps correctly as

      1.putting c1 & d1 values as 1 & 0 in sampling scheme.

      2.Enter this sampling scheme in sampling procedure with valuation as " attribute".

      3.when you have Qualitative char /mic then you can follow above procedure

      for Quantitative char you have to select k factor along with valuation as "variable"

      4.Use this sampling procedure against each MIC in task list.

      5.make manual lot & check the result recording by rejecting the one sample.