on 10-20-2011 6:43 AM
Hi,
I am getting an error while executing the assessment cycle through KSU5.
I have defined the sender from one Cost center group and one cost element group. similarly assigned a receiver cost center group.
while executing the assessment cycle in test mode getting the error " .... does not include any senders.".
Can some one suggest the pre-requisites for KSU5.
Thanks & Regards
the following are very general observations:
1) did you check if the cost elements are created (including assessment cost elements)
2) Are there any postings in the sender cost centers/cost elements for the given period.
Satya
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
The message says the system does not find any value to be transferred.
Check for the cost center group and cost element group assigned in the cycle whether any booking exists in those cost centers for those cost element for the period you are executing.
Regards,
Divraj
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
1. Check Secondary Cost Element and its Category
2. Assessment Cycle - Sender/Receiver Tab : Sender Cost Centre & Cost Elements Range From & To / Group, " which were not included "
Regards
Sridhara Rao D
Edited by: Sridhara Rao.D on Oct 20, 2011 8:01 AM
Edited by: Sridhara Rao.D on Oct 20, 2011 8:02 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
103 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.