Skip to Content
0
Former Member
Oct 14, 2011 at 05:14 AM

Reuse Table created using AET in CRM 7.0 EHP 1

82 Views

Hello,

I have created table using AET for Lead transaction and displayed it as a assignment block. This works fine.

Now I want to reuse the same table in Opportunity as an assignment block. When open the configuration page and go to show enhancement, after clicking on the 'ADD REUSEABLE TABLE' I am able to select the table in Lead. But after this it should be shown in assignent block but invain. I also had a look into the Tcode bsp_wd_cmpwb for oppotunity but even there in the configuartion page it is not showing up. How do I show this reusable table as assignment block on opportunity page.

While creating the table in Lead it showed only 'ORDERADM_H' under which the table is created. While in opportunity after adding the table using 'ADD REUSEABLE TABLE' , if I try to add new table it shows 'ORDERADM_I' only .... why so?

I did not find any document on this... but yes there are few on 'ADD REUSABLE FIELDS' accordingly it should show up... don't know where I am going wrong.

Regards,

Jaya.