no adequate data message on Bex

[Former Member]

Hi gurus,

I am using Bex 3.5

I have a query that was working fine yesterdat.

When i Check the infocube and view the data it is ok.

When I run the query i get a no adequate data message and get no data. But the information is in the cube, i can see it in BW checking the data from the cube.

What can cause this message in this cases?

Thanks!!

[Former Member · Accepted solution]

If there are objects in the cube marked for Authorization, check if you have used variables of type 'Auth' in the query.

[Former Member]

It was a residual timeout error of a test load :S

When i erased the petitiot all turned ok.

[Former Member]

Hi,

Are you using any filter or variable restrictions on your query?

If yes , please check in your cube whether you have any data in cube with that particular combination or not.

You can also try to remove all filter restrictions and excute the query in full and then check whether you get the

data or not.

Also make sure to check whether are you using any Aggregates , this could also be be cause.

Regards,

Amit

[arvind_doomra]

Hi,

Run the report in RSRT and this way we can come to conclusion whether the problem is with frontend( Bex analyzer )

or its some other issue.

Regards,

Arvind

[former_member188080]

Hi,

Try to run the query in RSRT and see in SU53 whether you are getting any authorisation error.

check whether you are entering the right selections or not?

See if you need to debug by putting break point on any exit variable.

Thanks and regards

Kiran