Skip to Content
0
Former Member
Sep 24, 2011 at 05:50 AM

Result Recording from one inspection lot to another inpection lot

16 Views

Dear,

I have taken te following setting and also change the setting. But result don't copy from previous lot. Though I have set in inspection plan for every MIC Origin results data = 02 Previous Inspection Lot.

SPRO Setting:

Control in Insp. Lot - 2 Automatic Data Transfer at Sample Calculation.

Control in RR - 2 Automatic Data Transfer When accessing Results Recording

Close - Make Tick mark

Origin TL - No setting

DatOrig.RR - 02

Selection - 300

Mapping - 100

Log - Make Tick mark

After putting the previous lot no then error comes out. Error is given below:

Error: Data selection procedure 300 could not find any data

Plz give me solution......