how to revert the changes once the repair flag is reset in se03

[Former Member]

Hi All,

In Development box once i made a change in transfer routine and captured in a Tranport Request. But instead of Development/Correction subtask i got Repair subtask.

Later i went to SE03 and found my object and gave Reset Repair Flag then again captured the object in New Transport Request.

Again i got the same Repair subtask.

i trasnported the Request to quality and production. Though the request moved successfully but because of some version change my loads got failed.

1.How could it be possible to get repair in Development system

2. how to now rever the change, as hw it was before the repair reset.

I need you expert help as it is a bugging problem.

[Former Member · Accepted solution]

Hi Sapoorani,

To revert the changes, first goto your developement -->utilities >version>version management-->select old version of the object -->Retrieve(Ctrl+F5). This way you can retrieve your old version.

Pls let me know if you have any queries.

Regards

Bhaskar

[Former Member · Accepted solution]

Hi Arani,

Thanks for your reply.. but i think you are speaking about ABAP code changes.. But i did my change in Transfer Structure (3.5 flow). I need to revert those changes..

[former_member209728]

Hi Annapoorani,

Please go through the following link.

http://www.saptechies.com/correction-and-transport-system-2/

Hope this helps in resolving your doubt.

Best Regards,

Kush Kashyap