on 09-20-2011 5:20 PM
Hello,
Apology to ask a basic question which was asked many times previously.
I have gone through almost all the thread related to upgrade requirement but the responses are to refer upgrade guide. I have gone through the upgrade guide twice but haven't found any section related to minimum requirement for 46c or ECC5.
Is there any fact sheet available from SAP about the minimum support pack & Kernel requirement to upgrade 46c / ECC5 to ecc6 ehp5? I am not looking any document for the add-ons ST* or third party but for the SAP standard (ABAP, BASIS, APPL etc)
Regards,
-Sunil
Hi Sunil,
As you are on 4.6C i assume you would do the Unicode conversion along with the Upgrade.
There is no minimum support pack requirement.Please reffer note 928729
Source Release Target Release CU&UC Guide
-
4.6C (no minimum SP) -> NW 7.00 (SP 15-21): CUUC46C_to_NW700SP17.zip
4.6C (no minimum SP) -> NW 7.00 (SP >= 22): CUUC46C_to_NW700SP22.zip
4.6C (no minimum SP) -> NW 7.01 (SP >= 07): CUUC46C_to_NW701SP07.zip
4.6C (no minimum SP) -> NW 7.02 (SP >= 05): CUUC46C_to_NW702.zip
However while performing upgrade if you would like to use ASU then there is a prerequisite for ST-PI addon
Prerequisites
Your source release SAP system must contain add-on ST-PI with one of the following minimum levels
2005_1_<46C/620/640> SP08
2005_1_700 SP06
Regarding Kernel its always advised to have the latest kernel before starting Prepare.
Please go through the Upgrade guide thoroughly.You will find most of the answers there itself.
Regards,
Ershad Ahmed.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sunil,
Upgrade to ECC does not require a minimum support package of the start release.
(Exception: The component ST-PI must be on support package 8.)
However, it is important to consider what has to be included in an upgrade in order to not "downgrade" the existing functions. In this regard, support packages have a so-called equivalence attribute that tells you to which SPs from lower or higher releases these SPs are equivalent
Please visit below link for more information.
Thanks,
Tushar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sunil,
There is no minimum support packages required in source systems such as R/3 4.6C or ECC 5.0 before upgrade to ECC 6.0 EHP5.
U must have latest SPAM update, tp, R3trans in source systems .
In rare cases, when u execute upgrade prepare script or Checks phase of STARTUP script may detects that in source system support packages for Service Tools Plug in like ST-PI or ST-PI/A and or Plug-In basis i.e. PI-BASIS is too low.
Regards
APR
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
94 | |
11 | |
10 | |
6 | |
5 | |
5 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.