Error Code 3 during upload data from Infopackage to Cube

[Former Member]

Dear All,

Error:

I am using the simulate upload mode from PSA to Infocube to upload and check some data in order to resolve an issue which is that xxx data are correctly transferred to infocube, but none added !

And runing this simulation the following error message appear :

Diagnosis

the upload delivered the error code 3.

Procedure

You can find further information on this error in the error message of the update.

Question :

Someone could tell where I find further information ? I don't know how to open the error message of the update ?!

Thanks a lot

[Former Member · Accepted solution]

Hi dear,

where exactly are you receiving this error (before or after your update rules ? debugging only one record ? any record ?)

Bye,

Roberto

[Former Member · Accepted solution]

Issue explanation -

---

I have start infopackage , with processing only PSA.

I go on the monitoring, and do simulate update on the datapackage 1.

and when I perform the simulation, if I have selected Select Simulation records, or the other one ...

The following error message appear at the end of the process.

21.02.2005 15:42:14 Error 3 in the update RSAR 119.

Procedure

You can find further information on this error in the error message of the update.

Question----

---

Could you explain me how to find more explanation about the issue, the procedure message is not really explicit

[Former Member · Accepted solution]

Ok,

in order to do your simulation, try to load (via PSA) into your cube and not only in PSA...then try again your (post) simulation, select one record and execute...

let me know...

[Former Member · Accepted solution]

Ok thanks a lot Roberto.... I have now some possibility of investigation ...

[Former Member · Accepted solution]

THANKS A LOT ROBERTO.

My issue was on a start routine run on this update rule.

Thanks to help me to resolve this point, and progress on BW.