on 09-07-2011 5:39 PM
Hi
I get this error, " Recorded for outbound processing ", when I run the interface. When I go to the queue, it says SYSFAIL. I updated cache and all.
How do I resolve this error?
Ajith
Hello,
If you are facing SYSFAIL Error then in SMQ2 first unlock(without activation) that queue and activate it.
it will resolve your problem.
Monica
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
I have noticed one strange configuration. The same set of interfaces has been configured for different flows between SRM and SUS. I guess that's why messages are going into " Recorded for outbound processing " state. It's like this, SupplierPartner_out is the sender interface in one scenario and SupplierPartner_In is the receiver interface in one scenario. Here the flow is from SRM to SUS. In the next flow, SupplierPartner_out is the sender and added to SUS, SupplierPartner_In is the receiver in second and its added to SRM. Two scenarios are configured exactly opposite. RA, Receiver Com Channels are all configured accordingly.
So will one work if I dfelete the other scenario ?
Regards
hi ahith,
visit the below link for small inf...
http://saptricks.com/smq1-outbound-queue-statuses/
thanks and regards,
kesava
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.