Skip to Content
avatar image
Former Member

BPM 1:N split into different service interfaces

Hi everyone, just a quick question about multimapping scenarios.

If I want to make a 1:N message split in BPM I should use a transformation step and specify a multiline container element to get the result of the transformation. That multiline container element is bound to a single message type so, If I want to split my incoming interface into different service interfaces (based on different message types), how can I handle that in BPM? Or is it just not possible?

Thanks in advance.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Sep 05, 2011 at 09:41 AM

    Hi,

    This is a very common and simple requirement. No need for BPM

    Add two receiver interface in Interface determination

    Create two mapping program.

    First Mapping: Source to Target1

    Second Mapping: Source to Target2

    So for every message will be routed to two different interface.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Thanks Debashish Roy, I hadn't read last part of your previous reply when I wrote my answer.

      So it is not only possible but mandatory to specify more than one container if the operation mapping result in different message types. Thanks for your help 😊 Case closed then.

      Thank you very much.

  • Sep 05, 2011 at 09:46 AM
    Add comment
    10|10000 characters needed characters exceeded