Skip to Content
avatar image
Former Member

How to fill up set up tables for 2lis_03_UM and BF?

Hi,

I am working on Material movements, and i have a How to do document. According to that, its showing me to fill up set up table for 2Lis_03_bf by using TCode OLI1BW, and in the very next step its again telling me to fill up set up table for UM, by using the same TCODE ( OLI1BW ) .

Now, if i do that, how would the system know that it has to fill up set up table for BF and then UM ? , no where in the screen its asking to fill up the Data source.

OR i just have to fill up set up table ONCE, and it will fill up for both the DS ?

please help.

thanks

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Aug 30, 2011 at 02:36 AM

    Hi,

    You will have to use OLI1BW for 2LIS_03_BF and OLIZBW for 2LIS_03_UM data source setup tables.

    Regareds,

    Durgesh.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 30, 2011 at 02:53 AM

    Hi Honar,

    You can always run the setup table filling in parallel.

    run the jobs in back ground.

    Regards,

    Venkatesh

    Add comment
    10|10000 characters needed characters exceeded

  • Aug 30, 2011 at 06:44 AM

    Hi,

    Look at following thread as well

    Thanks and regards

    Add comment
    10|10000 characters needed characters exceeded