on 08-24-2011 4:27 AM
Hi Gurus,
I have maintained inspection plan. When I check it found below error.
Char. 0020: sampling procedure SMP02 cannot be used
Message no. QP215
Diagnosis
The sampling procedure cannot be used. This may be due to one of the following reasons:
The sampling procedure:
is locked
does not fit the characteristic type
does not fit the inspection point indicator in the plan header
Procedure
Select another sampling procedure.
In sampling procedure,Sample type is 100 Fixed sample & Valuation mode is 700 Mean value within tolerence range,Control chart type is 901 Shewart chart for x-bar/n=1/Sample
Where do I wrong.
Check the header of inspection plan ...you must have used inspection points.Remove tit & try!!
or
In if you wnat to define Inspection points then sampling procedure defination QDV1/2 there is radio buttons for
inspection point.Tick it
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sujit,
In inspection plan header below setting are there & I can not change it.
Inspection point is 200 Inspection point for physical sample
Sample drawing procedure is mainatined
Dynamic modification level is 3 Dynamic modification at char Level
Pls tell me where to do change so I can not face any error in inspection plan.
One last reply
1.If your char is quantitative type then select the valuation mode as one of the "variable " type
2.If your char is qualitative type then select the valuation mode as one of the "attribute" type
means say for 700:Valuation of mean value within tolerance limits
Valuation of a quantitative inspection characteristic according to the mean value in relation to the tolerance limits.But if you try to use this sampling procedure to a qualitative type mic then it will not work
]
User | Count |
---|---|
94 | |
11 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.