on 08-23-2011 6:15 AM
Hi,
What is the feasible way to isolate certain components in PDS while ciffing from ECC?
To be more precise, there are 10 componets in BOM in ECC and require only 5 components out of these in PDS while ciffing.
Thanks,
Prash
Hi,
I assume your requirement as out of 10 components in BOM, you want to plan only 5 components in APO. In that case, you should set the MRP type of your header and only the 5 components as X0. Other 5 components may have different MRP type.
Also, make sure that you transfer only those 5 APO relevant components material masters. not all.
Then, while transferring PDS, this will automatically transfer only those 5 APO relevant components to APO.
If this requirement is not correct, please elaborate your requirement.
Regards,
Manimaran M.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
8 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.