on 02-02-2005 10:28 PM
Hi All,
There are three aggregation options:Minimum,Maximum,Sum on the Aggregation Tab when creating a Key Figure on the Admin Work Bench. I understand that these aggregation rules are set for the Key figure BEx default settings. Does this affect at all how the data is loaded into the cube?
Another question. If I have a Key Figure that I have set to Maximum, and would like to change to Sum.. Do I need to unload the data in the cube and load it again?
Thanks.
Hi,
it is not possible to change the aggregation option of a keyfigure when it is already used in a cube and data loaded to the cube.
regards
Siggi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
> There are three aggregation
> options:Minimum,Maximum,Sum on the Aggregation Tab
> when creating a Key Figure on the Admin Work Bench.
> I understand that these aggregation rules are set for
> the Key figure BEx default settings. Does this affect
> at all how the data is loaded into the cube?
Indeed: these are report relevant settings only.
> Another question. If I have a Key Figure that I have
> set to Maximum, and would like to change to Sum.. Do
> I need to unload the data in the cube and load it
> again?
I'm not sure about this one: Since it's a report-relevant setting only, i wonder there would be a reason why all the cubes where the KF is used should be empty...
(you can always change the setting directly in table RSDKYF, field AGGRGEN)
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.