on 08-08-2011 10:13 AM
Dear all!
I set keyfigure type is number and Defines 3 as the number of decimal places in which this key figure is saved. But I cannot put decimal number in the Interactive Planning Tabble.
Is there any wrong?
Thanks!
Hi,
Please check your planning area - key figure details. there for your key figure, you must have maintained decimal places. Please check.
Regards,
Manimaran M.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
As Ada said already, it can be done through Planning book design mode only.
Select the particular row. Right click. Select 'Selected Rows --> Decimal places'.
This will open up a popup 'Setting the decimal places'. here uncheck the check box 'Value from UoM table'.
Then you will get buttons for increasing/decreasing decimal places. set number of decimals using these buttons.
Click OK. This will close the pop up.
Save the design by clicking Live button or Save button. in the pop up, select 'All functional areas' and save.
Now the key figure can have/ display decimal places. I tested this and it worked.
Regards,
Manimaran M.
Hi,
Please go to the design mode of the data view (not palnning book).
(In interactive planning book, click 'Design' button.
Or in /sapapo/sdp8b, input planning book and data view, check 'Data view' radio button and push 'Change' button.)
Right click on a key figure, in the context menu, 'selected rows' -> decimal places.
Best Regards,
Ada
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
9 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.