Error on creating a TO - Control data for storage type is missing

[Former Member]

I am creating a transfer order t.code LT03. I am getting the following error with details below. I am at my wits end. I tried everythingthat I could possibly try. I am in IDES using a lean WH. Can anybody help?

Thanks in advance

Control data for storage type is missing

Message no. L3006

Diagnosis

No control information has been defined for the entered storage type.

Procedure

Check your storage type entry.

If you have entered the storage type correctly, contact your system administrator.

--

Paddy Viswanathan

[Shiva_Ram · Accepted solution]

Check in the path SPRO->Logistics Execution->shipping->picking->Lean WM->Define storage type. Here check whether any storage type has been assigned or not. If assigned, then the material master has to be created/extended with same storage type details in the warehouse management views. In Warehouse mgmt1 view, make sure stock removal and stock placement strategies and storage section details are maintained.

Regards,

[Former Member · Accepted solution]

Thanks for your reply.

I was able to resolve it, based on your suggestion.

But I am unable to Post GI after the TO has been created. However, I will close this and create a new thread, If I am unable to proceed further.

Thanks again.

Paddy