Skip to Content
author's profile photo Former Member
Former Member

Error message when executing a report

In the report I have an advanced calculation of a key figure including several other restricted and calculated key figures. When I run the report in the development environment, which has little test data, I get an error message and can't open the report:

"Messages:

Entry 6X3IFXMIJEI0X7U0IZJMIVBHZ not found in the DKF"

Probably this is because the values for some of the key figures can't be found in the cube and the calculation is therefore stopped? Is there a way to suppress this error and go on with the calculation of my key figure so that I at least can open the report? In the live environment I don’t want the report to dump whenever a value is missing.

Add a comment
10|10000 characters needed characters exceeded

Related questions

2 Answers

  • Best Answer
    Posted on Jan 27, 2005 at 07:34 PM

    Did you check out Note 750156...

    Add a comment
    10|10000 characters needed characters exceeded

  • Posted on Jan 27, 2005 at 10:39 PM

    Hi,

    You can enclose the formula of the calculated key-figure within the NOERR() function. This way, if there is any error with the calculation of that key-figure, it will be displayed as zero without affecting other key-figures.

    Regards,

    Somnath.

    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.