Hey everyone,
I would like to know if there is a simple way to find out for a datasource when you do an initial load that there is no action allowed in your source system on the data of your datasource.
For example I want to load the Master data of Business Partner should I load when there are no changes done on Business partner in the source system or can I load it when I want. Other example for LO cockpit I know for sure that when you load your setup table everything needs to be locked but not for other datasources.
Can somebody give me a good and simple way to find out.
Thanks in advance.
Greets,
J
2 Answers
-
Best Answer
Former MemberPosted on Jan 25, 2005 at 11:09 AMHi Jeroen,
while runing a initial load you can do whatever you want in your source system. There is only one restriction: If you are running a setup for your setup tables (only available for LO customizing cockpit data sources) users needs to be blocked from the relevant transactions until your setup finished and you scheduled a 'init delta' package (which can be without data transfer) for the data source. From now on, users can run their transactions again and at the same time you can run your initial load (which goes to the setup tables). The actions of the users will goto the delta queue.
Hope this helps a bit,
regards
Siggi
Add a comment
Add a comment