Skip to Content
avatar image
Former Member

Deployment Issue - Fair Share A

Hi Folks,

Here, we got an issue in deployment runing. Deployment method is Fair Share A.

Issue description: after location heuristic, we got that DC1 needs to deploy material A to DC2 and DC3. Distribution Quantity is 10 for DC2, and 84 for DC3, meanwhile, ATD Quantity is only 40.

After Deployment run, 10 of ATD Quantity has been deployed to DC2, but remaining 30 did not deploy to DC3.

I don't know why the remaining 30 of ATD Quantity didn't assign to DC3. As we know, As per Fair Share method, 40 of ATD Quantity will be deployed to DC2 and DC3 proportionally. in this case, DC2 will get 4 and DC3 will get 36 of ATD Quantity.

Could you please give some instructions?

Thanks & Regards,

Quanyin Su

Edited by: Quanyin Su on Jul 19, 2011 4:55 AM

Edited by: Quanyin Su on Jul 19, 2011 4:56 AM

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Jul 19, 2011 at 05:39 AM

    Hi Quanyin,

    It looks that fair share rule probbaly is not being considered and entire quantity is going to DC2.

    Please check product master settings of product A at DC3.

    Easier thing will be to compare product master setting at DC2 and DC3 location product master.

    Also, if TL exists from DC1 to DC3 and it is valid.

    Regards

    Datta

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi,

      I have compared the product location combination in MAT1 for DC2 and DC3, all of settings are same except Rounding value and Minimum Lot Size in subview Lot Size. Do you think it's because of the Rounding Value?

      I also checked the TL for DC1->DC2 and DC1->DC3, TLB Profile is difference between each other, but the total volume and total weight calculated with the value distributed proportionally from ATD Quantity is below than the constraint in TLB profile. therefore I think TLB is no issue.

      Thanks & Regards,

      Quanyin Su