on 07-12-2011 5:31 PM
Hi All,
After READ/TRUSTED RFC connection working fine form SolMan to satellite system,stil when in do LOAD MONITORS in BPM
Use button LOAD MONITORS and select <satellite system> Then return, but nothing happens:
For <satellite system> last reload date n/a.
Regards,
Neni
Hello,
do you have valid ST-A/PI plug-ins installed on your respective backend system (satellite)? You should also check if the respective RFC connection is pointing to the right client.
Other than this there is not much happening from a visible standpoint once you load the definitions. Only once you go into the real configuration of key figures the corresponding F4 value helps are filled once the load monitors is performed. Oterhwise the value helps remain empty.
Best Regards
Volker
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Volker
Thanks for the reply.
ST-A/P1 01N_46CAPO in backend system satellite.
You should also check if the respective RFC connection is pointing to the right client.yes its 001
Only once you go into the real configuration of key figures the corresponding F4 value helps are filled once the load monitors is performed--I am doing it from F4 its noting geting loaded
Regards,
Swaroop
Hi Swaroop,
ST-A/P1 01N_46CAPO sound like you are still operating some APO 3.0A or 3.1 system. Is this correct? If I am not mistaken we never shipped any monitoring content for such old APO releases. Our APO key figures starte with APO 4.0 or 4.1. So then it would be no surprise that nothing is loaded. For such old APo systems you could only utilize the general background job monitoring and the "old" qRFC monitoring based on CCMS and transaction RZ21.
Best Regards
Volker
User | Count |
---|---|
93 | |
11 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.