Skip to Content
avatar image
Former Member

Create Inboud Delivery

During the Create Inboud Delivery (VL31N)

After I had put the storage location in this transaction, the system shows the message u201CMaterial 10018978 1100 cannot be used in inbound delivery because QM is activeu201D. This storage Location is controlled by WM , this is a ROH Material and We need the QM actived but it was not possible to create inboud. What I have to configure in WM to accept this process ?

Marcos

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Jul 07, 2011 at 05:00 PM

    Hi Marcos,

    I have understood from the item 3 from Ramana's reply that you may perform goods receipt from MIGO for example right over the Purchase Order. It seems then VL31/VL31N cannot be used indeed.

    BR,

    Christian

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Dear Christian

      In fact, in our process we need to generate a inbound delivery before Migo, because at that moment we havenĀ“t the material to receive yet .

      Thanks

      Marcos.

  • avatar image
    Former Member
    Jul 06, 2011 at 04:47 AM

    This message was moderated.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 06, 2011 at 12:19 PM

    Hi Marcos,

    ************************************************************************

    The error message is basically correct because the use of a QM-relevant

    material in inbound deliveries is currently only possible on a

    restricted basis.

    1. If the item of an inbound delivery is relevant for a HU-managed

    storage location, a QM-relevant material can also be used. If the

    "Inspection for HU" indicator is set in the relevant inspection type

    (01 Goods receipt inspection for order), an inspection lot is

    created when handling units are created in the inbound delivery. If

    this indicator is not set, no inspection lot is created. An

    inspection lot is not created either in the later goods receipt

    posting for the inbound delivery.

    2. If the item of an inbound delivery is relevant for a

    decentrally-managed storage location, system behavior is identical

    to the one above with active handling unit management. This behavior

    is produced by the attached correction. To date, the above error

    message L9528 appeared in such a constellation.

    3. If an item of an inbound delivery is relevant for an integrated WM

    management storage location, the system still generates error

    message L9528 since this process is not currently supported. In this

    case, you cannot carry out your goods receipt processing via an

    inbound delivery but can only carry out it via a goods receipt

    posting to the purchase order.

    ***********************************************************************

    Kind regards,

    Ramana

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Dear Ramana

      I checked this forum that I can not use the VL31 for this case without applying the note 491500. Is that right?

      Thanks

      Marcos