Skip to Content
avatar image
Former Member

Contract qty update in SRM

Hi SRM gurus,

Using a classic version of SRM 7 & ECC 6.Created a central contract with a target qty 500 and this was distributed to ECC.

1. In ECC, I create a release order with ref to this contract for 10 qty. Then I can see the open target qty (500 - 10 = 490) in ECC under release order document. But this is not updated under release tab of this contract in SRM

2. But if I create a direct PO from SRM using this contract, then release tab is updated and ECC release order document is also updated.

This is standard behaviour?

Thanks in advance,


Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Jul 04, 2011 at 12:24 PM

    Hi John,

    I can only tell you that this is not standard behaviour, the contract data should be updated on SRM side as well if you release in ECC. You might need to check whether every XI/PI and SOA service is set-up. The following SOA service seems to be required for contact updates (inbound): Purchasing Contract Release In

    Details via: []

    Kind regards,


    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member


      In WE20 of my SRM system, I cannot see SC7CLI001. There is only ECCCLI001 with BLAREL as inbound parameter. That is why I am in a fix as to why wrong partner no is coming.

      In ECC system, outbound IDOC BLAREL correctly shows destination of SRM system, but after coming into SRM, the partner no is SC7CLI001 instead of ECC.

      Any suggestions??


      Edited by: SRM_query on Jul 5, 2011 6:24 PM

  • Jul 04, 2011 at 04:29 PM


    Is it a value contract or Quantity contract?

    BLAREL is only main check point.

    every item data has a release data of the purchase order.

    Add comment
    10|10000 characters needed characters exceeded