on 06-29-2011 7:02 AM
I have a infocube with aggregate built on it. After request was loaded to cube,the aggregate rollup job failed. It did not give any error message. But in request tab of the cube, there is aggregate indicator in Rollup Status column. We tried to delete this request but because of the aggregate indicator, its not allowing us to perform any action on the cube.
Is there any way to remove the aggregate indicator from request tab of the cube.
Hi,
You have to deactivate your aggregate to make it proper.
But again you have to refill (Initial fill) the aggregate
Regards,
Suman
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
It should allow you to delete the request eventhough the Request is set to aggregate rollup. I guess, there is an inconsistency formed while updating the aggregates. Either, you deactivate the aggregate and fill it or try to idetify the lock on the cube and remove it. both should work.
Rollup should have locked the cube, try to idetify and remove the same.
Regards,
Venkat S
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Whenever any load fails in loading data into aggregates, you need to deactivate all the aggregates built on top of this infoprovider then only you will be able to delete the request.
And you just need to deactivate and not to delete the agreegates.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
81 | |
10 | |
10 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.