Hi All,
When making changes to a query, that I want to be reflected in the flex front end, I carry out the following steps:
1) save the query in query designer
2) load up the SPM user interface, navigate to Administration -> Data Source Administration
3) Click on "Refresh All Data Sources"
4) Wait for the "wait" cursor to finish (only takes a few seconds)
5)log out of the portal
6) clear the browsers cache
7) reload the web page
8) Repeat Steps 2-7 again
9) the query's changes are not reflected in the UI
Does anyone know what I should be doing differently so that the query changes are reflected in the Data Source?
Kind regards,
Neil