Skip to Content
0
Former Member
Jun 07, 2011 at 04:42 PM

SPM: Using "refresh data sources" in Data Source Administrator

123 Views

Hi All,

When making changes to a query, that I want to be reflected in the flex front end, I carry out the following steps:

1) save the query in query designer

2) load up the SPM user interface, navigate to Administration -> Data Source Administration

3) Click on "Refresh All Data Sources"

4) Wait for the "wait" cursor to finish (only takes a few seconds)

5)log out of the portal

6) clear the browsers cache

7) reload the web page

8) Repeat Steps 2-7 again

9) the query's changes are not reflected in the UI

Does anyone know what I should be doing differently so that the query changes are reflected in the Data Source?

Kind regards,

Neil