on 05-30-2011 11:01 AM
Hi All,
I've problem when config CO-PA for characteristic (KES1) and its displayed :
The following syntax error occurred in program "SAPL0KEA " in include "L0KEAT00
" in
line 433:
"The Dictionary structure or table "*T2580" is either not active or doe"
"s not exist."
I've check t2580 in se11 .. it's showed that table didnot exists ...
then i've my basis implement oss note 64990 & 942784 ... and i run se38 for RKEAGENV , it displayed :
Delete function module TABLEFRAME_ from function group 0KEA
Delete function module TABLEPROC_ from function group 0KEA
program RKEAGENV already same with the OSS 101940 ...
I've run se38 : RKEAGENF and re-generate again my operating concern ... but there was the same error, when i used RKEAGENV ...
then i create again char but with assign table t2580, but still showed the errors when i used KES1 but now in :
line 433:
"The Dictionary structure or table "*T2581" is either not active or doe"
"s not exist."
I've check t2581 in se11 .. it's showed that table didnot exists ...
Is there any solution?
THX,
David
Hi,
Please run RKEAGENV and RKEAGENF and regenerate the operating concern and check if that helps
regards
Waman
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi David,
As I understand, the notes which you have mentioned should have resolved your problem.
Please check the table TVDIR, you can search T25* table list. you may get clue.
Other best thing is to raise OSS message ( I m sure you must have raised by now). some times its difficult to understand what is going wrong without looking at the system.
Thanks & Regards
Kalpesh Chavda
Hi,
In the standard system the functions that should exist for the function group 0KEA are TABLEFRAME_0KEA and TABLEPROC_0KEA.
Entries like TABLEFRAME_XXXX and TABLEPROC_XXXX 'XXXX' being space are in this group by mistake. Somehow these funtions were created in the function group 0KEA.
They can be deleted since are incorrectly included in this function group.
After deletion please regenerate operating concern
Afterwards generation of views via RKEAGENV should proceed successfuly.
regards
Waman
Hello Guru's
I have same problem
I am not able to find the table TABLEFRAME_0KEA
TABLEPROC_0KEA can u please help me to how to find these in OKEA
When we enter OKEA its showing the message like logon language differs from original language.
Two tabs showing Maint in orginal lang & Maint in logon lang
Hi Waman,
Thanks for your post, i have done the same thing as per your mentioned in comment, the only thing is i have not execute another program i.e RKEAGENF, only first program i.e (RKEAGENV) i have run and checked the T.Code KES1 its working fine. Thank you so much.
We are using S4 HANA ,
Is it required to run RKEAGENF ?
Thanks & Regards
Pranav Kumar
User | Count |
---|---|
100 | |
11 | |
11 | |
6 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.