Skip to Content
0
Former Member
May 29, 2011 at 06:52 AM

Tranformation Transport Error RC 8

832 Views

Hi Experts,

I am getting the below transport Error (RC 8) when I transport a transformation.This transformation is a copy of a Activated & working transformation which is already present at Production system.

Rule (target: 0SUBTOT_1S, group: 01 Standard Group): Syntax error in routine

I checked start routine ,end routine expert routine but no syntax error exits in the routines..also tried to transport is again using a new transport request but that ain't woking either.

PLZ suggest wat else I should do to solve this issue.

Thanks

Aman