on 11-23-2004 10:15 AM
hai all,
i have to load data from cube to another cube. so i have taken all the necessary steps for this. i.e.
1. exported the data source for the source cube.
2. replicated the datasources.
3. activated the communication structure.
4. created and activated the updated rules.
but the problem is i am getting zero records from the source cube, even it has got 5000 records.
for your info there no error requests which are marked yellow or red for this cube and also there are no aggregates associated with this cube.
the message i am getting is
<i>No data available
Diagnosis
The data request was a full update.
In this case, the corresponding table in the source system does not
contain any data.
System response
Info IDoc received with status 8.
Procedure
Check the data basis in the source system.</i>
try to execute this program that activate the infosouce:
transaction SE38
RS_TRANSTRU_ACTIVATE_ALL
execute the program and than input the name of the infosouce of the dataload in the cube.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Vijay !
I think you are still facing the problem occurred some days ago...if you are not set anything in the selection tab of your infopackage, and you are sure that there is some record in the fact table of your source cube...
just a thought, do you have defined your destination cube with a reference to the source one ?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
90 | |
10 | |
10 | |
10 | |
7 | |
7 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.