Sender AS2 adapter

[Former Member]

Hello All,

i am doing scenario where edi document from external party goes into sap system as an idoc (i.e. edi to idoc scenario).

i done all configuration party. when i am testing my interface through configuration test it is working successfully. but it is failing in sxmb_moni saying "No receiver could be determined".

Eventhough i create proper recevier determination and recevier agreement.

could you please answer my question.

[Former Member]

Hi,

Apart from the above suggestions, since you have labelled the post as Sender AS2 adapter, are you using parties in the sender business system?

If so, when creating your Receiver Determination, please select the option "sender uses virtual receiver" and then in the ensuing screen, put your receiver party/business system.

So in your Receiver Determination, the receiver party and component would be mentioned in 2 places, under receiver and configured receiver.

Regards

[Former Member]

Check you sender system & interface and make sure the receiver determination is made for this combination. I'd say the main mistake is here.

if not, try to recreate due to cache.

[Former Member]

Hi,

there are many possibilities for the receiver determination error.

1) Configuration mistake

Receiver determination depends upon:

a) Sender business system

b) Sender Interface

c) namespcae under which sender interface is configured in ESR

Check for the values in MONI and compare them with the config (Receiver determination) in ID.

The above values should match in MONI and ID.

So please check each and everything.

2) Cache refresh (please check cache notifications in ID)

3) When the business system not found in SLD.