on 11-09-2004 11:54 AM
In the online doc for adapters in XI 3.0, it refers to SAP Notes under the section for Additional parameters. Has anyone found these Notes?
/Elling
Following notes exist:
File/Ftp-Adapter: 801926 (no additional parameters so far)
JDBC-Adapter: 801367
Regards
Stefan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Here is the text of the note:
Symptom
In the File Adapter documentation it is stated that parameter settings
for the parameter table in the "advanced mode" section of the
configuration are documented via OSS note.
Other terms
J2EE XI 3.0 30 Adapter Engine File Adapter
Reason and Prerequisites
You are looking for additional parameter settings. There are two possible reasons why a feature is available via the "additional parameters" table in the "advanced mode" section of the configuration, but not as documented parameter in the configuration UI itself:
Category 1: The parameter has been introduced for a patch or a SP upgrade where no UI upgrade and/or documentation upgrade was possible. In this case, the parameter will be moved to the UI and the documentation as soon as possible. The parameter in the "additional parameters" table will be deprecated after this move, but still be working. The parameter belongs to the supported adapter functionality and can be used in all, also productive, scenarios.
Category 2. The parameter has been introduced for testing purposes, proof-of-concept scenarios, as workaround or as pre-released functionality. In this case, the parameter may or may not be moved to the UI and documentation, and the functionality may be changed, replaced or removed. For this parameter category there is no guaranteed support and usage in productive scenarios is not supported.
When you want to use a parameter documented here, be aware to which category it belongs!
Solution
The following list shows all available parameters of category 1 or 2. Please remark:
Parameter names are always case-sensitive! Parameter values may be case-sensitive, this is documented for each parameter.
Parameter names and values as documented below must be used always without quotaton marks ("), if not explicitly stated otherwise.
The default value of a parameter is always chosen that it does not change the standard functionality
File Sender Adapter parameters
= No parameters available up to and including SP10 =
File Receiver Adapter parameters
= No parameters available up to and including SP10 =
hi,
Please refer to note 793922 which refers to Additional module parameters.
In my case I wanted to set additional parameters for File Receiver adapter.
hope this helps,
sachin.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
94 | |
11 | |
11 | |
10 | |
9 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.