Skip to Content
avatar image
Former Member

Planning book values for certain key figures show doubled up numbers

currently on SCM 7.0, we are facing a strange intermittent issue of doubled up values in planning book for certain key figures when compared to the underlying Infocube.

This happens when the Input process step happens, some times when the process step fails in chain and is run again.

After its run then we load data to the planning book , then when the key figures show up for the current week bucket they show Doubled up values

We tried to run a consistency check /SAPAPO/OM17 (DP time series option) but no result.

Can anyone mention what could be the reason ?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    May 09, 2011 at 11:04 AM

    Hello,

    This may be one possibility: If you have used "Add data" option inside Keyfigure assignment (//tscube transaction) then thevalues will get added to the old ones which is already existing in that keyfigure before you run //tscube.

    Thanks and Regards,

    Nithin.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi,

      Please check the data in the cube for the codes . There could be double request for the same keyfigure. When you copy from cube whatever value avilable in the cube gets into Planning book.

      Transaction : LISTCUBE

      Solution : Delete the old request and check the value agina in cube. Execute the TSCUBE.

      Thanks,

      Jeysraj