Skip to Content
avatar image
Former Member

Inspection lot creation on storage bin

Hello all,

I am wanting to learn how to create an inpection lot of stock within a storage bin.

I ask because we have many storage bins in our warehouse location storing the same material.

If I do a MIGO 322 transaction in inspection lot there is no where to specify bin location, it looks at the warehouse as 1 storage location.

In the lower half of the migo screen there is a 'storage bin' section but it is blocked out and I cannot identify which storage bin I am wanting to inspect within that storage location.

I know I can create a transfer through LT01 however this still doesn't appear in QA32 inspection lots.

I want the bin location to stay in the same storage location but be flagged for quality inspection.



Edited by: gmanwizo on May 7, 2011 5:58 AM

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • May 09, 2011 at 06:44 AM


    It seems you have both MM and WM activated. You have to assign storage locations to warehouse numbers in customizing, definition of organization step. Then when you do a 322, transfer requirements will be created by the system and you can transfer the material to a storage bin by turning the requirement into a transfer order. Assignment of new storage locations to warehouses may be tricky, you better ask for consulting on this matter.

    Add comment
    10|10000 characters needed characters exceeded