Skip to Content
author's profile photo Former Member
Former Member

Runtime error GETWA_NOT_ASSIGNED during GI for STO

Hi,

In PRD we are getting Runtime error GETWA_NOT_ASSIGNED during GI (Mvt 351) for STO. This is for the line item which was added later to the STO. Before adding the line item the GI and GR was already created for the previous items without any problem.

Please advise.

Regards,

Pratap

Add a comment
10|10000 characters needed characters exceeded

Related questions

3 Answers

  • Best Answer
    Posted on May 06, 2011 at 10:11 PM

    Hello Pratap,

    Are you using any user exit, BADI or 'Z' program ?

    Please note that the error 'Field symbol has not yet been assigned' or

    GETWA_NOT_ASSIGNED can occur if the field in your output table is a

    type P field but the description for this field in the fieldcatalog is

    defined as a character field. Please make sure that for this fieldname

    the DATATYPE or INTTYPE in the fieldcatalog is the same as that in your

    output table.

    Please use the consistency checker as per the attached note to assist

    you:

    504384 - ALV-SOS: Consistency check

    I hope it helps you.

    Fábio Almeida

    MM Consultant

    Add a comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on May 06, 2011 at 06:03 PM

    Hi,

    check below thread

    GETWA_NOT_ASSIGNED

    thanks

    Diwakar

    Edited by: Csaba Szommer on May 6, 2011 9:24 PM

    Add a comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on May 09, 2011 at 01:02 PM

    Resolved the issue with the following work around:

    When we do MIGO GI and give the STO number, all open items should be displayed. But in this case it went to dump. But when the line item number was entered along with the STO number it worked and we were able to post the GI.

    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.