Skip to Content
avatar image
Former Member

REgarding Info update indicator in PO

Hello Gurus,

There is no EVO parameter set in user profile.But still while creating PO ,system still taking Infoupdate indicator in PO.

Please let me know whr this tick is coming from?

Thanks

santosh

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    May 04, 2011 at 03:12 PM

    By default system checks infoupdate indicator

    If you want to uncheck then change the default values for purchasing are defined at SPRO-> MM -> Purchasing - >Environment data -> Default values for Buyers.

    There you define the default values under 2 digit code.

    Change Info record update indicator for PO to blank and assign this to user

    For an user the default code is to be assigned under user settings own data. System -> user profile -> own data and under parameters tab add a new parameter ID "EVO" and the code(01 or 02).

    This is the place where the default values are linked to the PO and the user ID.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi

      Regarding EVO Check sap note;-202173,it may helpful to you

      this is from sap notes

      The system does not use the default value for the InfoUpdate indicator in the purchase order of the EVO parameter. Customizing in transaction OMFI

      Consider the following two scenarios:

      There is an info record in the system.

      The system looks in table T160V (that is, Customizing in transaction OMFI with user parameter EVO).

      1. There is an entry with InfoUpdate indicator 'A':

      If an info record exists at plant level, the system overwrites this with the value 'B'.

      If no info record exists at plant level, the system proposes the value ' C' by default.

      2. There is an entry with a 'blank' InfoUpdate indicator or with the value 'B' or 'C':

      The system always transfers Customizing from OMFI.

      3. There is no entry (' ... ') and no user parameter is assigned:

      The system sets the InfoUpdate indicator with the same logic as for the InfoUpdate indicator 'A'.

      There is no info record in your system:

      The default value for the info update indicator is determined by Customizing.

      1. There is no entry (' ... ') and no user parameter is assigned:

      The system sets the InfoUpdate indicator to 'A'.

      General logic (independent of the info record):

      1. There is a 'blank' entry and no user parameter is assigned:

      The settings that are stored for the 'blank' entry are used.

      You can choose to make 'blank' the default setting of the InfoUpdate indicator for all users. You can do this by maintaining the InfoUpdate indicator entry as 'blank' for the 'blank' entry in Customizing.

      2. The InfoUpdate indicator is 'blank', 'A' ' B ' or 'C' and the condition maintenance for the plant is activated:

      If only plant-specific conditions are allowed, the system overwrites the value with 'B'.

      If no plant-specific conditions are allowed, the system overwrites the value with 'C'.

      Regards

      Kailas Ugale