cancel
Showing results for 
Search instead for 
Did you mean: 

Transfer of counter reading from one MP to other

sai_chandra
Explorer
0 Kudos

Dear experts,

we have created measuring points as a counter to an equipment to record the hour meter reading (say 200 hrs reached).

Due to some fault the hour meter has replaced with new one and new hour meter starts from 0 (zero hrs).

Now what should a solution for my criteria

1) my data capture should be continuous (I should be able to record present data for new hour meter which starts from 0.00(zero hrs))

2)there should be a provision to assign old record(i.e 200 hrs (past) + 1 hr (present))

3)How the maintenance calls will get effect if the old measuring point has already assigned to a maintenance plan.

Shall I create a new measuring point if so how the above requirements will fulfill?

Thanks in advance for your valuable posts

Regards

SAICHANDRA

Edited by: SAI CHANDRA M on May 4, 2011 2:13 PM

Accepted Solutions (0)

Answers (4)

Answers (4)

sai_chandra
Explorer
0 Kudos

Thanks

former_member494495
Active Contributor
0 Kudos

Otherwise

Make the instrument counter to 200 hrs.

or

you need to reverse all the measurement document upto initial reading

former_member494495
Active Contributor
0 Kudos

Hi,

If the old meter is showing 200 hrs. Change Your counter over reading as 201 and make it to zero hrs.

Then count from zero and enter the counter over reading as per the new meter

former_member187991
Active Contributor
0 Kudos
sai_chandra
Explorer
0 Kudos

Hi Sir,

Thanks for your quick response.

The link you have provided shows,

Procedure

In the screen General Data for the measurement document, choose Edit ® Replace counter.

The dialog box Replace Counter is displayed.

Select the field Counter replaced.

Choose Continue.

You return to the screen General Data.

Save the data.

but in my screen "replace counter" field is in disable mode, please tell me the config settings needed to enable it.

I couldn't find the field with the following path img>Plant Maintenance and Customer Service>Master Data in Plant Maintenance and Customer Service>Basic Settings>Measuring Points, Counters and Measurement Documents>

Thanking you,

SAICHANDRA.M

former_member187991
Active Contributor
0 Kudos

Hi

Try to enter new reading in IK11 after specifying the counter reading access the menu EDIT>Replace counter , it will be in editable mode

regards

thyagarajan