Skip to Content
avatar image
Former Member

Access sequence: wrong field (output message)

Hallo Gurus,

I have created an access sequence for the determination of an output message.

The access is for Saleg Organization (field VKORG).

In VF02 no message is determined because the system uses field Doc.Type (FKART)!

How is it possible?

Please, help...

Thank you very much indeed!

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    May 04, 2011 at 09:31 AM

    In that case, check have you determine you output type for your Billing Doc or not.

    If it there then goto the change mode of the Billing document in VF02 and in the output (Header/Item), goto the output Determination analysis. Check the output type which should trigger, there you will find detailed info why it was not triggered

    I hope this can assist you.

    Thanks & Regards

    JP

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Do u mean to say

      System is showing wrong field against long field lebel in following path?

      SPRO-Maintain output determination for billing documents-maintain access sequence-access-fields

      Regards

      Atul

  • May 04, 2011 at 09:10 AM

    Hello

    You need to maintain condition record for output in TCode VV31 for your output type for your combination.

    Thanks & Regards

    JP

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Lakshmipathi Ganesan

      Access sequence is correct. But the field is wrong.

      It takes the wrong access, the one with Doc.Type instead of the one with SalesOrg.

  • avatar image
    Former Member
    May 04, 2011 at 11:56 AM

    Hi,

    in NACE->Select V3->Output Type->Select your output type->give there access sequence & check other options also.

    Thanks

    Trupti

    Add comment
    10|10000 characters needed characters exceeded