Skip to Content
author's profile photo
Former Member

Wait time between DTP and InfpoPackage

Dear All,

Is it possible to set a constant / dynamic delay / wait time between a DTP and infopackage. I've following scenario in my PC:

DSO --> DTP --> Open Hub Destination (AppServer-Folder) --> InfoPackage --> Flat File DS

Regards,

Ender

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • author's profile photo
    Former Member
    Posted on May 04, 2011 at 07:26 AM

    hi,

    if this flow is in process chain, then yes you can include a delay by using debug loop.

    Right click on Open hub destination introduce debug loop, give the delay in seconds that you need to introduce.

    regards,

    Arvind.

    Add comment
    10|10000 characters needed characters exceeded

  • author's profile photo
    Former Member
    Posted on May 04, 2011 at 07:56 AM

    Hi,

    You can also use the "Interrupt Process" ( Under the Node : General services)..........If you have some idea that at what time the DTP will get completed.......and suppose you want to execute after one hour of the completion of the DTP..........then you can give the time in the Interrupt process.........

    The process chain will be stopped in this process till that point of time.......

    Regards,

    Debjani......

    Add comment
    10|10000 characters needed characters exceeded

  • author's profile photo
    Former Member
    Posted on May 04, 2011 at 08:48 AM

    Hi Ender,

    There is a easy way to do this .

    Go to PC ->edit mode ->right click on process ->Debug loop ->it will ask for waiting time in seconds .

    For some of the processes it shows option wait in place of debug loop.both are same .

    Hope this will be helpful .

    Regards,

    Jaya

    Add comment
    10|10000 characters needed characters exceeded