Skip to Content
author's profile photo
Former Member

how to copy a calculated key figure into another physical key figure

Hi Friends,

My requirement is to have an a calculated key figure and get it copied into another Keyfigure with the help of planning Or BEx.

I am using BI IP.

I am new to BI. Please help me.

Regards,

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    author's profile photo
    Former Member
    Posted on May 04, 2011 at 04:47 AM

    Hi svkulkarni

    You can implant the calculation in the FOX. For example: You have a calculated K.F CA_KF. And his calculation is: 0AMOUNT * 10%. And you to copy it to ZAMOUNT. In FOX just copy 0AMOUNT to ZAMOUNT, and multiply it by 0.1.:

    ZAMOUNT=0AMOUNT * 0.1.

    Hope this is yuor requirment.

    Yuval

    Add comment
    10|10000 characters needed characters exceeded

  • author's profile photo
    Former Member
    Posted on May 04, 2011 at 05:14 AM

    Hi ,

    You can achieve this in BEx.

    Suppose your CKF is ZCKF1 .

    Now create another CKF as ZCKF2 and in the formula editor write a formula : ( ZCKF1 <> 0 ) * ZCKF1 .

    This ZCKF2 will be your copied CKF .

    or if you are asking about copying the value if CKF into a physical key figure , i think you can achieve this through APD .

    Hope the above reply was helpful.

    Thanks & Regards,

    Ashutosh Singh

    Edited by: Ashutosh Singh on May 4, 2011 7:15 AM

    Add comment
    10|10000 characters needed characters exceeded