Skip to Content
avatar image
Former Member

solman_setup not working

solman 7.0eph1, when im trying to configure solman_setup I am unable to login its simply executing but not getting logged in .

This message is coming up:

No switch to HTTPS occurred, so it is not secure to send a password

when I m trying to log user with wrong password its giving a reply wrong userid or password

when I m entering correct user id and password its simply executing on the same page

Edited by: letzfriend on May 2, 2011 11:38 PM

Edited by: letzfriend on May 2, 2011 11:58 PM

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    May 03, 2011 at 09:26 AM

    Hello,

    Which version of IE are you using? and have you set the profile parameters correctly before you begin Solman_setup?

    Regards,

    Hasan

    Add comment
    10|10000 characters needed characters exceeded

  • May 03, 2011 at 10:41 AM

    Hi

    as per SAP security guide this issue get resolved by changing the protocal from HTTPS to HTTP.

    Increased security: The HTTPS protocol guarantees secure data transmission at the same level as
    modern security standards for RFC/SNC communication and other interfaces. You can change
    default settings for services if you do not maintain an HTTPS - connection and you are required
    to enter your user and password (message in the logon screen: No Switch to HTTPS occurred,
    so it is not secure to send a password):
    1. Choose transaction SICF and the according service (/default_host/sap/bc/webdynpro).
    2. Select tab Error Pages and choose the button Configuration.
    3. Change the protocol selection.
    4. Save.

    Please chect the page number 38 on the below guide

    [solution manager security guide|https://websmp210.sap-ag.de/~form/sapnet?_SCENARIO=01100035870000000202&_SHORTKEY=01100035870000718044&_OBJECT=011000358700000370562009E]

    Thanks,

    Jansi

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Same issue here.

      NEW Install of Solman 7.1, upgraded to SPS03, tried to run solman_setup ... blank screen.

      No error messages, just nothing.

      Also tried to switch to HTTP ... not working.

      Profileparameters are set. Main page of http://<solman>:8000/ is working.

      Netweaver Administrator (/nwa) is working, too.

      But not the solman_setup. I don't think that this is a IE issue, because my second Solman (7.0ehp1) is working fine.