Skip to Content
author's profile photo
Former Member

Pick list generation error

Hi all

we implement an basic WMS based on ECC6 on out WH. Everithyng was fine for more than a year. Recently i tried to do some changes in purchare order area to create a new document type. I am not sure there is a link between these but when i tried to create a pick slip from outbound, transaction VL06O i got following message:

Storage bin 0080002445 not found (enter storage type).

I rolled back all changes done for PO document type but error still is there.

This is happened in DEV system hence i suspect that some other changes might create this issue. There are no changes around LE

All config for storage type is correct.

Thank you

Silviu

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • author's profile photo
    Former Member
    Posted on May 01, 2011 at 02:58 PM

    Typically, on the outbound TO creation, the system generates a 'dynamic bin' based on the coordinates that refer to the delivery number. The creation is automatic during TO creation. First place to check is the combination of warehouse and warehouse movement type. Ensure the interim storage type (typically, 916) is placed in 'Dest' and 'scr' is marked. Additionally, ensure the 'requirement type' has 'L - Sales document'. This configuration enables automatic generation of the dynamic bin, which is essentially the delivery number. During VL06O (creation of TO) or LT03, system generates this dynamic bin to putaway material in this bin upon TO confirmation.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi

      config is fine, all settings are in place, no change were required. Problem still there. I read some other threads and one guy got some issues with ABAP...