Skip to Content
0

Async Sync Bridge error in the receiver channel using Do not use SOAP Envelope in SOAP Adapter

Dec 13, 2016 at 10:11 PM

478

avatar image
Former Member

Hi Team,

We need to configure Async Sync bridge for the below scenario :

Async(Proxy)-->SOAP(Sync)-->Proxy (Async) I have done the configuration as per the below blog with modules in the sender channel configured providing ECC SOAP(XI Protocol) channel as receiver instead of File.I had tested internally we are getting response from Webservice and it is fine but since the response will not be sent to communication channel where the modules are configured I would like to check if it will post to the inbound service of proxy or do I need to create other ICO and route the message to that ICO ?

I also configured the Async Sync Interface with modules in the receiver channel and configuring ICO1 and ICO2 but i am getting an error .Is it because I am using "Do Not use SOAP Envelope" in receiver adapter as we need to send Header details to Webservice by building SOAP envelope.sdn.jpg.I tried in both the ways of Asyn Sync bridge but method 2 did not worked with error.Could some one suggest ?

NotificationCreateUpdate_Sync_In is a synchronous interface defined for ICO1 that is shown in the error.

MP: exception caught with cause com.sap.engine.interfaces.messaging.api.exception.ConfigException: No sender agreement configured that matches the messages header fields (sender party: "", sender service: "BS_CLICK_DEV", interface: "urn:xxxxxxx/xxxx/xxxx/Notifications NotificationCreateUpdate_Sync_In", receiver party: "", receiver service: "DEACLNT800")

sendermodules.jpg

https://blogs.sap.com/2014/03/26/bridges-construction-site-part-13-asynchronous-synchronous-bridge/

sendermodules.jpg (90.9 kB)
sdn.jpg (111.4 kB)
10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

1 Answer

avatar image
Former Member Dec 15, 2016 at 09:55 PM
0

Hi Experts,

unfortunately both the configurations in Sender and receiver adapter module configurations are not working for me for aysync sync bridge configuration.Any suggestions please ?In sender when I configured it is throwing an error CPA object not foundException:Couldnot retrieve outbound binding for the given P/S/A values: FP=;TP=;FS=BS=Receiver;TS=Sender;AN=Sender Async interface;ANS=url ;in the current Context .

Does any one has any suggestion on the same ?

Share
10 |10000 characters needed characters left characters exceeded