on 04-27-2011 3:05 PM
There is a output type "KEP6" which i am triggering manually for hanling unit. it is getting triggered properly and also there is no problem when i save it.
But when i go back and again open the same handling unit, the output type which i saved earlier do not appear. i tried triggering several time but same problem persists.
i just want to know all setttings, i have to check to make sure that the output type can be triggered manually. also let me know if there are some things, i have to check while triggereing the output type.
Hi spiyush,
similar problem happened to me as well.
I was using transaction HU03 for manual entry of output message into HU; after several tries, i discovered that updates in HU (in our case, output message entered) are not actually getting saved even though confirmation pop-up for saving is shown.
So, correct transaction for this purpose is HU02.
This way, manually entered message is correctly saved and you can find it again thereafter.
Hope this info is useful for you.
Andrea Ghirardo
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
104 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.