on 04-18-2011 8:05 AM
Hi,
I have set the alert for mapping in PI 7.11 from alrtcatdef & the RWB.
Applied similar procedure to do it for adapter related errors, but no alert is generated.
i defined a alert category in alrtcatdef and a alert rule in RWB. Fixed user is also assigned.
I am using "SXMS_TO_ADAPTER_ERRTXT" to catch such error via alrtcatdef.
Thanks,
Vishal K
Hi Vishal,
Run the report SXMSALERT_LOGREADER in se38 and check what exact error you are getting for alerts.
-Supriya.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI Vishal,
You are not getting any alert, because there is no error getting generated in adapter engine.
To test whethere you will actually receive any alert or not, You have to create some dummy mistakes in your receiver communication channel. Then adapter engine will catch your error and generate the alert as well.
For dummy mistakes means.
Try , to give some path for file or archive which is not existing. make it sure that check box for create directory must be unchecked.
In advance mode, You can put some file size limit and try to process file greater than that.
Br,
Sumit Gupta
Hi Vishal,
Have a look into below blogs.
/people/michal.krawczyk2/blog/2005/09/09/xi-alerts--troubleshooting-guide - Alert Trobleshoot
/people/michal.krawczyk2/blog/2005/09/09/xi-alerts--step-by-step - Steps
Alerts with variables from the messages payload (XI)
/people/michal.krawczyk2/blog/2005/03/13/alerts-with-variables-from-the-messages-payload-xi--updated
Regards
Aashish Sinha
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I have set the alert for mapping in PI 7.11 from alrtcatdef & the RWB.
Applied similar procedure to do it for adapter related errors, but no alert is generated.
are you able to get alert messages for mapping failure?
check in RWB if you have un-selected Suppress Alerts of this type.
Also refer the alert trouble-shooting blog by MIchal and the corresponding SAP note
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
9 | |
9 | |
9 | |
6 | |
6 | |
5 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.