PLM Integration with AutoCAD

[sunny_pahuja2]

Hi All,

We have a requirement to integrate PLM with AutoCAD. But problem is our client wants to use only SAP connectors for that and does not want any third-party connectors for the same. Do you know any SAP standard connectors are available for that ?

I have not found any documentation on the same. If any of you have any idea for the same, please share it.

Thanks

Sunny

[Former Member · Accepted solution]

HI Sunny,

Accordiing to your question, your client is not going to use thrid party tool (for example CIDEON for Autocad).

So for connectors you have Enterprise connectors, but i dont have docuements on that.

Thanks,

Tarun.

[sunny_pahuja2 · Accepted solution]

Hi Tarun,

Thanks for your reply. Could you please refer me some link or SAP guide for the same ? If you don't have, could you please explain more for the Enterprise Connectors ?

Thanks

Sunny

[Former Member · Accepted solution]

Hello sunny may I know why your client wants to Re-Invent the Wheel? Though Cideon is a 3rd party tool it is certified by SAP. I f you want go the enterprise connector path, it would mean lot of development and re-engineering. I personally don't recommend the 2nd path.

regards

N K

[sunny_pahuja2 · Accepted solution]

Hi NK,

I understand the same but It is because of cost factor. So, Could you please give me some link where I can check Enterprise Connector so that I can present some points to client ?

Thanks

Sunny