EA-FIN Extension Set

[Former Member]

I have activated EA-FIN via SPRO and there were no errors or issues in the logs.

However, when I check the asset values and click on the "depreciation trace" the old screen appears. Did I miss a config setting somewhere? Please advise

FYI ... I also did this in our sandbox but it worked just fine there.

Thanks in advance

[Former Member]

Issue Resolved:

The main issue resides with the fact that we just updated our system with EHP4. The EA-FIN extension did not activate fully. We have submitted a note to SAP for further review. In the meantime, I would check three main points:

1. Make sure your system settings are correct via t-code SCC4. There is an SAP specific note that explains this (Note 855959)

2. Make sure that the following three BC sets are active:

There are 3 Classical BC Sets to be checked for any Extension set "EA-xxxx" -

1) EA-FIN-IMG

2) EA-FIN-MENU

3) EA-FIN-AKH

3. Check table TBE11 an make sure the EA-FIN extension "check mark" is there, meaning if fully active.

Hope this helps

[Former Member]

This message was moderated.