Sales retrun Process in QM

[Former Member]

Dear All,

I am having a clients requirement where once the FG material is returned through 06 Inspection type using QM.This material goes to sales retrun.Now the requirement is to identify whether this retruned material can be reworked or needed to be destroyed. For this I need to inspect it.

Please advice how do I can achieve this.

Regards,

Vivek

[anand_rao3 · Accepted solution]

Hi Vivek,

There could be several ways to achieve this. Kindly note that inspection lot generated under 06 origin is stock irrelevant. (No stock posting possible)

Method 1

1. Transfer the ok stock to unrestricted use by 453 movement through MB1B.

2. If the material is reworkable then transfer the stock to block stock by 459 movement through MB1B.

3. After rework if ok, transfer to unrestricted by movement 343 through MB1B

4. After rework not ok, you can execute 555 movement through MB1A, to scrap from block stock.

Method 2

1. You can transfer the entire stock from returns to quality inspection by movement 457, through MB1B.

2. This will generate inspection lot, against which you do stock posting as per the case as you do for regular lots.

Method 3

1. You may use inspection type 05 instead of 06.

2. This will post the stock directly to quality inspection instead of returns with inspection lot generation.

3. Do stock posting as per case against this lot.

Regards,

Anand Rao

[Former Member]

Answered