Default macro is not saving values

[former_member503200]

We created a macro for a calculation and its updating a KF, the macro is kept in default mode. But when we check the updated KF in a different view, the values are not showing. Though we saved in initial step, the values are not reflecting in different view. The macro is just addition of 2 KFu2019s. Any help is appreciated.

Thx

Jeff

[former_member503200]

Thx for your help. We resolved this issue, by changing the input mode of the data view. Its set to not to update.

thx

Jeff

[Former Member]

Hi Jeff,

If the values are not saved in liveCache then thevalues of keyfigure in different data view will not get updated. But after running the macro, once you click on save in //sdp94 values should get updated in livecache. I kindly request you to do the following.

• Execute the macro, save the value by clicking on Save button.

• To confirm whether values are updated or not, what you can do is remove the macro from the default event, then load the selection.

• Check if the keyfigure has value after you have saved.

• If the keyfigure value is updated in this planning book, then value should get updated in different data view if you are loading for the same selection.

I hope the above information was of some help.

Thanks and Regards,

Nithin.

[Former Member]

Hi,

I am not sure which support pack you are using.

Please find the OSS note released recently

OSS note - 1566631- Some DP macros show erratic behavior.

It might be useful for you.

Thanks,

Jeysraj